Hardware Flow Control Does not work in Teraterm
Eröffnet am: 2022-07-30 01:34
Letztes Update: 2023-03-26 12:31
| Auswertung: | john_smyth | Verantwortlicher: | (Keine) |
|---|---|---|---|
| Priorität: | 5 - Mittel | Meilenstein: | (Keine) |
| Typ: | Fehler | Schweregrad: | 9 - Höchste |
| Komponente: | Hardware/Driver | Status: | Offen |
| Lösung | Keine |
Einzelheiten
Hardware flow control in Teraterm setup does not work using CTS and RTS. I am using an RS232 real serial port (not a USB to RS232 cable or USB to TTL cable).
I have tested this Hyperterminal and it is working. Something is wrong with Teraterm. Data is lost when using Teraterm most likely because it ignores the CTS/RTS signals.
I am using TeraTerm Version 4.106.
Kommentar
thank you for doing that. it compiles with no errors (lots or warnings but that is ok) Regards